Recent content by 7_nebo_7

If using syringe you don't see any ink in it then more likely cap top not attaching properly to a head. If you already replaced head I will recommend pull out carriage across the print table and carefully look if head seating parallel to a table. If it is on angle then there is your problem. If...

Do you have photo of the problem. IT could be something simple as a dirt stuck under the carriage or unlock mechanism too low, to some more complex as damaged CR cable, encoder touching encoder strip, head cables, CR board, Print head or main board. I would start from simple things and go step...

Head in this machine last about 7-12 months. If it is more, keep it as a bonus!

I believe person asked here for help and not on someone personal limited opinion. To solve his particular problem he need to load new ink data file in to emulator. It been proven for many other printers that these devices works.

You just need to load new file into the emulator. e-mail to the lfp-repai-service they will provide new one if you originally bought it from them.

MikaChip going to work just fine for you. Just google it.

Went across this topic. Very curios to see what is outcome going to be. I don't think you have many choices on electronics? I have done numerous projects on Mxtexr, AxWx, DxS, HxsxnSxft, and BxxX electronics. My latest experience was with i3200 and i1600 heads. Very good price per nozzle +...

A recent development in 3D printing is Chip Bypassing Kit for FormLabs Printers. This kit enables users to use alternative resins while continuing to maintain the full functionality of FormLabs 3D printers. Using the existing cartridge, Bypassing Kit replaces the resin chip in FormLabs’ Form 2...

Hi I have a lot of one time Mimaki ink chips various ink types CS100, SB411, TP400, BS4, SB54 Here link on e-bay. https://www.ebay.com/itm/195621570519

I am selling SB411 one time ink chips for Mimamki printers. https://www.ebay.com/itm/195704704261

I agree with Solventinkjet it looks like electronic fault. Why did you replace print head at the begining? Have you replaced head cables? Maybe one of the pin damaged...

Also do not forget about media temperature.

I have more than 20 sets avaliable Mimaki CS100 one time chips. CMYK Full level of ink expiry date in Feb 2025 Price lower than any suplier. https://www.ebay.com/itm/195621570519

Just littlebit theory how the system works there. Main board send PWM voltage (41V 25Khz) to the motor via driver located on the main board to DC motor. Motor rotating pulley, pulley moves the CR belt and carriage. Then CR encoder attached to carriage reading encoder lines and passing to the...

On what print speed Y2 current appears? slower or faster? Have you tried to replace encoder strip, check position between cr encoder sensor and the encoder strip. Try loose carriage belt for 1-2 rotation of the ajustment screw. if problem appears try another way. Y2 current could be tricky one...