Recent content by avdodooel

aa dobre, misleh 4e e sy6tia :) mersi.kvo zna4i ,,nakrainik? dali maps moje i na cjv30-160bs ili samo na cjv30-160?

moje da govorim na facebook? tam podobre da te pitam nekoi raboti ako iska6 da mi kaje6. Mersi :)

solvent inks the model is cjv30-160 BS

Oh you ment the green connector? i think its not. And it is cjv30-160BS, its older model so i dont think it have maps

Kak misli6 kakyv cvqt e na nakrainika? english :)

Mersi bratle :) Nqkak izglejda6e mi kato banding da pravi, i misla6e 4e treba da promenim glavata :)

this is from the printer i would like to get.

Hi. I am looking to buy a used mimaki cjv30-160bs. We aranged on price with seller, but when i saw the nozzle check, i backed up a little. PRinter prints good but i can see some banding, seller tells me i can get that with feed media comp fixed, but when nozzle check was printed i can see some...

I changed a print head and itt prints fine, and only on the right side there is 1cm banding, after 70cm there is 4 cm banding. And when the head goes to the caping stations to refill, and restarts the printing i get this horizontal line like ink drop out for 10mm and after that it continues to...

I changed the printhead and it prints fine, and only on the right side there is 1cm banding, after 70cm there is 4 cm banding. And when the head goes to the caping stations to refill, and restarts the printing i get this horizontal line like ink drop out for 10mm and after that it continues to...

I am not using the LC and the LM. I changed the printhead and this fixxed. now this thing happnes. It prints fine, and only on the right side there is 1cm banding, after 70cm there is 4 cm banding. And when the head goes to the caping stations to refill, and restarts the printing i get this...

Hi there. Do you still use the converted printer?

Did you fix this? I am having the same problem with my fj52 converted to eco solvent :)

I had this issue before. Either dirt or heat settings too low. Crank that heater up!