I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
I don’t think she’s being too picky. That is really bad for a vehicle wrap. I personally would not even start printing that. I usually look at the file full scale before sending to RIP and if pixelated, I send the customer screenshots to show the pixels and to confirm they are aware it will...
Did you make the cutter active in Onyx?
You have to first make the cutter active in Rip Queue under File, then Manage Cutters. When you choose the cutter to make active you can press the configure button for settings.
The way I print, I open the file in Job Editor and on the first page of...
If you’re cutting stripes, letters, graphics etc. remove the film before you send to the cutter. If you apply the transfer tape to the film, it will only lift the film, not the vinyl and you will have to premask all over again.
Any suggestions of what to do in regards to the above error code? Has anyone ran into it before?
The screen said “Yellow slot ink level sensor overpressure or malfunction”
3 cartridges are now faulty due to this error. 1 it happened to last week and 2 today. I’m not sure if this was the error...
A lot of the time when I do an alignment or such, that is the way my magenta looks depending on the material. The one I use to check my printhead quality isn't that one. I'm currently away from my printer, but I know the way to get there is to go to:
>Settings
>Image Quality Maintenance
>Clean...
The cutting mat from Yellotools is absolutely amazing. The quality is superb. I love it. Mine is 59" x 24ft. Having it all in once piece versus 3 mats pushed together is awesome. I've had it for over 2 years now and I'm still on my first side of use. It's a little bit hazy from all the cuts, but...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.