Recent content by bootlegcraig

In my shop, I cannot change the settings and it prints the “R” barcode first. That leaves the “F” barcode out. When I then laminate that roll, the “F” barcode goes in first, leaving the “R” barcode out. The problem is that If I cut with the “R” barcode the rollers roll over the decals and...

Just called Onyx. It's not part of the FC9000 SDK (but was for every model before it for some reason), so it's not something they intended to implement, as it could cause mark scan errors. They said they'd look into seeing if it was something that could be done with the developers, but not...

I generally just do perf cut without contours but when I do, I have them both occur in the same press (over the channel). My biggest issue with cutting from "R" is that the decals want to pop out, even with perf tabs, and then the rollers bunch up the vinyl because it can't grip the whole width...

It definitely scans either barcode, it's just that when it does, the direction it cuts isn't what I want it to do. When scanning the "R" barcode first, it cuts as if it was feeding from the rear, out.... if that makes sense? If I'm cutting 15,000 decals out of a roll, I don't want the rollers...

Thanks for the reply. That rotates the image, but not the front and rear barcodes.

Thanks for the reply. I suppose for me, it's not that it's difficult as much as it's a waste of time. That 10 minutes or so every job adds up and is time I could spend doing a lot of other things. I generally use my laminator for this (I'm a small shop of 1), so to take the lam off, load the...

Hi there. Perhaps I'm just doing everything all wrong, but when I print on my Epson S60600, laminate, then cut on my Graphtec FC9000-140, I always end up with the "R" barcode facing out when working on roll-to-roll. It's a massive pain to have to rewind the entire roll through my laminator just...

Please tell me you downloaded all of them and still have them stored somewhere? All his links are dead now. :(

Thanks for the reply. I tried this (rotating cut file in Cut Server 180 degrees, saving and scanning barcode) and it still cut left to right, rear to front. ikarasu - any insight?

Hi everyone! Printing on an Epson S60600 and using Onyx 22 Gamma Print as my rip. When cutting with barcode on my Graphtec - is there a way to specify the path(s) the cutter takes? I know there's a "cut paths" box in cut server, but it's just an on/off without any real instruction or...