• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by cornholio

  1. CL catridges how do they actually work

    SP-540 has only 4 ink slots, because it has only 4 ink channels. So no CL cartridge during normal operation. XR has 8 channels. Depending on the ink configuration, only 7 are used by colored ink. Only then is the 8th slot is occupied by a CL2 cartridge. This is only done because otherwise it...

  2. Flushing Position Adjustment Doable on XR-640?

    This isn't needed, since the XR has a extra pad to spit ink. The VS spits the ink on the cap.

  3. A slight stutter a little hesitant on FC9000 when moving along the carriage.

    Could be a jumping timing belt.

  4. VG-540 Service Call 0400 [000A]

    000A=0008+0002 for example
  5.

    Need Help Inconsistent print

    It works on other media... it works

  6. Roland LEF2-200 second hand

    You need to do a complete flushing of the tubing and be prepared to replace all heads and dampers. Most customers I have print small high quality stuff like watch faces with these printers requiring the heads in mint condition...

  7. Question Roland VG640 scan motor replacement?

    These are brushless motors, that should make thousands of hours before they need replacement. I encountered quite many of them failing at 200-300h and after opening one out of curiosity, found some sort of haze on the encoder disc. I cleaned it with a bit of glass cleaner like Windex and tested...

  8. Question Roland VG640 scan motor replacement?

    There is a glass encoder disc inside the motor that needs cleaning. You need to remove the side panel to be able to remove the motor. Once you have it out, you need to unsolder the PCB to be able to clean the disk. Resolder and replace and you are good to go again.
  9.

    SP-540v won't cut

    Latest version for SP-540V is 5.51 Don't use transparencies together with cutpaths. To test, create a path with a spot color CutContour and save it as a EPS.

  10. In need of a VG RFW firmware file

    Firmware is the same for all sizes The DIP switch need to be set correctly on the board.

  11. Need Help Missing one side whole side of cyan print head suddenly.

    Sounds like electric defect of the head.

  12. Summa S2 erratic movements

    Erratic movements come from your data/driving software.(given the unit works as it should) Tracking needs to be analyzed. (Marks on the vinyl backing need to be clean, not "chewed") I had some units, where I needed to replace the drive drum. This has to be done during warranty by a certified...
  13.

    Could someone take a look at this nozzle check.

    Definitely the head. The black ink does that to the head after a couple of years.(EcoMax Black)
  14.

    HP 560 SMK3 issues

    Pay for the part, but not the labour and travel. That should be ok for both parties.

  15. ghosting on vehicles

    Probably not a problem on a Cyber Truck, if someone is brave enough to drive one
See more
Top