Recent content by Costaricanprinter

Do you print on 600x1200? We just got ours installed and that resolution is actually garbage I have the UVJ-100 too and in comparison 720x900 is actually a pretty decent quality Side by side I chose UJV-100 quality on mid quality On 1200x1200 there’s no visible difference

Thanks I will try it . Actually I have the problem that after a cleaning the printer doesn’t show 3 hours available only 1:59 hours

Can you guide me exactly where, I looked in the settings and couldn't find anything where to deactivate the 3 hours cleaning

As the title says, anyone has the service manual for the R5070L,a hose exploded but I managed to fix it, but now I couldn't manege to remove the code and make the printer go The only thing the technician did was ask epson whether to change the part, or not

Mine recently if you change the condition it loses arms calibration, has been a pain in the ass Until next Monday the technician comes, when I mentioned the problem he told me that it could be the damaged motherboard. This machine has 4 or 5 years is the first time that need some help all...

Just get my ujv100 and I really hate the white work flows Just wondering If flexi run this machine ok , the salesmen says MAPs. And other mímakis technology won’t work on other rip Sorry for My bad English

Yes, I contacted the technician, he just told me to turn it off when it happens I didnt make the report to technical service but in feel Epson's service in my country is a joke

Check the cables, try another lan cable

Today have this error mid printing , somebody know what this code is ? Can’t find error code list online

You are definitely printing on a very low temp , try increase the temp pre med and post heater’s

Btw, grinco post a video of this but on epson’s printers Maybe Can help you

I print on my epson r5070 .15 and .30 just like vinyl. At 9 pass you get a little grainiest but at 14 pass look like cast vinyl This are 9 pass , cut on a iecho pk Just made 500 under 2 hours is a very profit material

Maybe I explane my self wrong , on the 3641 I print die cut stickers the problem with the laminate happens on old the vinyls Here’s asome photos of the problem ,the sticker turns on a taco right when is cut on the graphtec

210 laminate , it’s something temporary… i—80 is way to expensive here ( Costa Rica ) The problem is the heat and profile , I am completely new to this print technology can’t figure out the right settings

Whats the lowest temp you can print And got a good cured? 90% of my prints are laminate Can I lowed the op number so use less heat on the cure process , got more than 10 years printing ecosolvent I thought the learning curve would be easier Sorry for my bad English,