Recent content by Dovermts

That kind of what i figured . Thank you !!

I have a valued jet 1204 that is set up to use bulk ink without smart cards at what level should I put the ink in the cartridges they are clear you can see through them I know you don't want to overfill should I go halfway or less than that? I've been just running them maybe a quarter or half...

I got the new print head in much better I will print an actual job now and see how it looks

Yes i was looking at the part that that want to use instrumentation That was over my head lol

ok so i took the yellow dampers off if i push cleaner through the head the cyan and the magenta on the respected side will slowly flow back to the tank. Id say thats bad right?

What color should i look at the yellow?

I never played with the rendering. If i do a cleaning and then a nozzle check it looks very good. If i let it sit a while then do a nozzle check my yellow will get a darker shade. It has to be a head leaking internally?? I was using cartridges now im on bulk. Issue was there before i switched. I...

Ya that's what I think too I will see if I can get a hold of them tomorrow and I will let u know what they say . Thank you for your help

Well i tried onyx it maybe helped a little. I'm not 100% sure but i think i have a bad print head. when ever i print blue its purple. If i print yellow it looks like brown almost. If i do a strong clean then print it will print a pretty good test. when i print a couple more tests the colors...

Yes I think I'm going to try that today. I will browe the net and see what I can get. I'm just spinning my wheels now LOL

Yes he unlocked the ink. I bought the printer used and cleaned the head. And replaced the dampers and maintenance station. I cleaned head by hand. I'm sure I didn't damage it. I also replaced the head ribbon cable while I had it apart. It prints and everything seems to work ok. I am using ink...

I had that guy unlock the ink. Could that have done something?

Ya I drew it up in inkscape then sent to flexi. I drew something in flexi and same result. I downloaded some test print pictures and they look bad too. The nozzle check is clear and clean it's so wierd

I'm using flexi 10.5.1 PDF rip