• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by henry67

  1. Full page ad for Computerized Cutters, Inc. in Signs of the Times

    Accu bend ACE+ good machnie? https://www.signs101.com/threads/computerized-cutters-ace-channel-letter-bender.137100/post-1531968 https://www.signs101.com/threads/computerized-cutters-ace-channel-letter-bender.137100/post-1532403
  2. Need Help JFX200-2513_System Halt (1)

    Exactly what I tested. Two Mimaki technicians have just arrived, they conclude that the power supply is broken. Thank you for your interest!
  3. Need Help JFX200-2513_System Halt (1)

    Yes. I have test all EMG switches. They are working good. No power output (36v)on the power supply. The 5V power input is good. See the picture below
  4. Need Help JFX200-2513_System Halt (1)

    Thank you for your attention. I've jumped the wire bypassing the EMG switch but the machine still won't start. Using ohm tool to measure, the wire and switch still work fine. I measured the volt output of the power supply and it was only 16.3 millivolts (instead of 36 volts). I unplugged the...
  5. Need Help JFX200-2513_System Halt (1)

    Please help!!! My JFX200-2513 had the same issue. 3 EMG buttons are release. I turned off the machine and unplug power cord then plugged it in and turned the machine on. The printer has no change: SYSTEM HALT (1) 19a: EMG PUSH .
  6. Considering Buying an AccuBender 410. Need some seasoned input/advice.

    https://www.signs101.com/threads/faulty-accu-bend-ace.165092/
  7. Computerized Cutters Ace channel letter bender.

    For about Accu Bend ACE, Check it: https://www.signs101.com/threads/faulty-accu-bend-ace.165092/
  8. Computerized Cutters Ace channel letter bender.

    I bought an Accu Bend ACE+ for $47,000. After 30 days of use, I discovered that the machine is faulty and wastes a lot of material such as can not bending the star, cutting wrong and not wide enough, causing the corners to overlap and wrinkle the corners. The curves of all letters...
  9. Considering Buying an AccuBender 410. Need some seasoned input/advice.

    I bought an Accu Bend ACE+ for $47,000. After 30 days of use, I discovered that the machine is faulty and wastes a lot of material such as can not bending the star, cutting wrong and not wide enough, causing the corners to overlap and wrinkle the corners. The curves of all letters...
  10. Anyone use Sign-in-China?

    This company doing business very bad I purchased JH 8150 $ 4,100 from Sign-in- China.com. They send invoice and I have paid in full. After taking customers' money, the company did not deliver as promised, but blamed them for their mistake. They asks the customer to pay over double the original...
Top