Recent content by lisa marie

oh so sorry roland versacamm 540I

i was trying to pull some ink thru the waste line and it wiggle up in the cap, and i pulled it with a needle nose plier, and it broke off. now i cant pull ink thru... any advice? i've searched for a part and i'm getting nowhere

i usually just get new panels, i just was thinking that they were just a few months old that they would strip off easy, we have had some serious heat, so im sure they just cooked on... oh well.... new panels are on the way.... now to find something to do with the old ones :) thanks for...

bummer.... was trying to save the new customer some money, can't believe alllll the glue stayed on,

ok, 4 months ago i hung 2 lexan backlit panels, they just came down for new customer, i stripped the panels, do i need to remove all the old adhesive prior to laying new translucent media? no ghosts.... adhesive is on every square inch of the panels... oi! just need to get this done asap...

dumb question.... should i be using the rip software thru roland? or strait thru flexi? i have been using flexi since i started.... would that make a difference?

soooo if i get this combo will yall help me figure it out? i am not properly trained on anything, but i can do layouts and graphics like a champ.. so stuck, i kmow a mutoh and a roland....

i print on perforated, canvas, gloss and matte comply oh and sometimes cling media

im just trying to cut 6" circles... sometimes its good, sometimes it scrap.... lost so much money this year do to misalignment with printing and cuts, replaced printheads...wipers blades, a 5k overhaul..... still just exausting.... i need to look into a summa productline

I am seeking opinions on a new printer, i am currently ready to throw my roland versacamm 540i into the highway, but its too heavy! anyways... what is everyone else using, i need 54'' and has to plot correctly (unlike roland)) and i would like it to be 110v so i dont have to rewire my shop...

went out to start a print job, sent it, it stopped after printing crop marks and threw a error/service code of 0007? cant print anything, i have rebooted machine and computer.. any advice?

question regarding dampers on vp 540 i

when i get over to my office i will take pictures and upload, thank you!

also, you are suggesting to replace those first, is that something that comes in a kit, im so sorry.. i just don't know much about these machines

ok i don't want to sound dumb, so i think i did the captops, they are clean as a whistle, my son cleaned the lines coming from the captops, is there lines elsewhere that are accessable to clean? and i did the wiper (rubber things by captop?) and unsure what the scraper is... any advice is...