Recent content by Mata

I recently reset my Graphtec fc9000 due an issue with the carriage. I now can’t remember how I connected it to my onyx. I set the cutter to use auto instead of hp-gl and gp-gl but that didn’t work. I’m sure I set this up like this before as I used both cutting master and onyx. I also tried to...

Turn off the sensor and you can print. I plan on buying a new sensor and seeing if that works.

All ok now, I didn't set the height of the head correctly when I put it back on. I needed to be 10mm above and I was lower which was giving me the error. All working now, thanks.

So I took the carriage off and checked for debris etc, bearings all seemed ok, put it all back together and now I am getting a cross cutter issue e01019. I didn't make not of how high the the motor part on the carriage went if that makes a difference. I can cut ok, just not cross cut without the...

Thank you, I'll take a look and contact you if I need any help. Thank you

Hi all I'm not sure if I am going crazy but watching the FC9000 cut some stickers I notice a slight stutter the head is moving along the carriage. It is cutting ok but vertically perfectly and when doing a die cut it is perfect, when cutting along horizontally especially on a die cut, the cuts...

did you find anything else?

As per the title, does anyone have the Service Program for Epson S60600 they don't mind sharing? I have a media width issue and I think the sensor needs replacing. I found the service manual online and it says you can check using the service program. There are copies on eBay but I'm not sure...

Load media error. When I load the media, the head moves top the left as it normally does and then I get the error. I have cleaned around where the sensor is but nothing changes. I don't seem to have a clear cover on mine like the one I saw on your tube (not sure why) but I cleaned around the...

Hi all I have a load media issue with my Epson S60600. I can't find an engineer in the UK other than the main Epson dealer (too expensive for a contract) and other than this issue, it's been fine. I'm assuming it's a dodgy sensor and easy enough to replace if I knew how. Does anyone have a...

Did you fix this? I have the same issue

Could you reshare the file please. I'm having issues with my 60600. Thanks

Hi all My Epson S60600 keeps coming up with a Load Media issue. I think I've narrowed it down to the sensor on the head. When I turn off the Media Skew, Media Width and the Media End sensor it loads fine. So one by one I turned them back on and it was the Media Width sensor that threw up the...

So I created my own profile in Flexi and it looks so washed out compared to my Onyx profile (custom profile created in Onyx 21). I could see the dots on the flexi profile where as the Onyx version seemed pretty hard to see, a very good print in my eyes on a sold colour. I've been fighting this...

Thanks Pauly I tried printing a few of the ink limit charts using various Dithers but Enhanced Stochastic seemed to work the best. I think I've nailed my process but I am going to repeat it using the Contone method and see how they compare. I know Flexi has a icc profile compare feature but is...