I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
I have been having an issue with prints from my 360 not curing. This has been on going for over a year sporadically and over the last few days it seems to be constant when I print matte vinyl and banner material. I have been thinking it might be related to the optimizer and replaced and out of...
I think I paid about $250-300 for the last single slitter I ordered. The Kala replaced a 4 year old RS 64" with take up that I purchased in my first year not knowing what kind of volume I would be dealing with having never dealt with laminator at this volume before, after 4 years the take up...
Can you print the barcodes on regular vinyl and apply them over the reflective? I am not sure of your work flow, but that is what I would try along with adding marks around the barcode for registration.
I appreciate this tip, I have had the Kala less than 6 months and had not considered this as an option. I was on the fence with between the Kala and top end GFP, then read some posts on here about the Kala's tracking; When my vendor said they had 10 in stock ready to deliver in a week I was sold.
I'd like to hear about this laminator and slitter sensors.
The Kala has auto leveling rollers so it skews very little if the set up is good. I have learned I am better running the full amount of prints I want to cut at once, because when my HP 360 and 365 stop and restart it knocks off the...
No quick set was set up for the media, I am bringing the into the job editor.\
Onyx is fail. I am going to re-install tomorrow.
This RIP used top be great, and now support is sine Jack Ass who thinks hie word is final/
Get used to eating duck , Josh. You have been with Onyx 1 year telling me I...
I am having an issue with Onyx displaying everything fine in job editor on a 96"x30" banner, but when it is sent to the queue the thumbnail displays correctly, but on the print preview shows the 96" length has been condensed, and prints condensed around 4". I am working with art that is a PDF...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.