• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by Northern Design

  1. Care to share your Epson experience?

    S40 Print quality is great, ink yield is fantastic, dry time great, non warranty repair $2600 per visit, they just changed there repair policy and screw the consumer. buy and retain the warranty or run away. D1 does the repair work, good people but short staffed. Not sure I would get another...

  2. Suggestions Insurance coverage

    I got the same question from farmers yesterday
  3.

    Window Perf Rolling Itself Off

    You should be using cold lam and not heating the material at 119deg

  4. Question signworld perf?

    Not bad stuff just use primer and edge tape, good for 3 plus years

  5. How many are running Networked Attached Storage (NAS) for your files?

    Synology

  6. Epson s40600 issue

    Did someone open a door and allow a cold breeze in to the room? It will look like ink drop out but returns to normal shortly after door is closed

  7. Question is a roland printer cutter more accurate on smaller jobs (cutting it's own job)

    Graphtec is better, Summa is best

  8. Which Machine to Buy

    S60600
  9.

    Flexi not showing contour cut

    This started in Flexi 19 they have me upgrade to ver 20, 21, 21.1, 22 and 22.2 still 50% not getting last leg of crop mark. This has cost a lot of money in materials and time. They have been on my computer many times never resolved

  10. looking for a print shop with a summa dc printer

    Contact Northern Design Graphics in Seattle Has a DC4sx

  11. Bright Colors Epson s80600

    Can this Epson Wide CMYK ver2 be applied in FlexiSign 10.5
  12.

    Purchased used SP-540V..need help

    Buy the clean cartridges and run per clean. Let sit over night and power clean 2 more times, pump dry and install your color cartridges. See how it prints, this should be done 1-2 times a year
  13.

    Epson Gs6000 issues

    Try heat settings- 35,35,50. If it still happens try 34,34,50 Good luck

  14. Help First Timer, My Cutter Just Omits Parts Of The Design

    Ungroup all parts before sending to cutter
  15.

    News We're Back Online With Our New Design!

    Change it back to the way it was before you screwed it up
See more
Top