I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Black ink isn't printing properly, but the other colors are fine.
Attached is a pic of the test print, as well as an actual print.
I've did a head soak, multiple cleanings and cleaned the encoder strip, but nothing changes it.
Any help would be appreciated.
Thanks in Advance,
Paul
On my VJ 1604, when I go to print a nozzle check (or anything else), a message comes up filling sub tanks, and after some time this error message comes on and all the lights start flashing.
Someone know how to correct this?
Thanks in advance,
Paul
I had a little issue. I ordered the print head for my 1604, and it turns out that my machine uses the newer print head that is used on the 1614.
So I've now ordered the correct one, and hope to have it on sometime next week.
Don't know if you've dealt with MacMedia before. That's who...
I ordered a print head for my 1604.
The print head came looking very similiar, but the manifold is thicker.
I sent them a picture to show the difference, and they said that mine looks like a 1614 print head.
However, they said that I could swap manifolds and it'd work in my machine.
Does this...
Chris,
When I first had it all back together, I received a cable error. I put the old cables back on (with the right bends, so the cable ends were at the correct locations).
Then it showed the "E085Err Head Heat" error.
I put my old print head back on... no errors.
Now I'm not sure if I...
Big ooops! That is exactly what I did.
I had also purchased new cables, and didn't put the correct bends in them, and I got them on in reverse.
In doing this mistake, does anyone have experience to know exactly what damage this causes?
If it's the main board, can it be repaired?
Thanks...
I just replaced the print head and turned on the printer.
It initilized and then the the lights start flashing and it shows an error message. E085Err Head Heat
Anyone have an idea on this one?
I took the magenta sensor off, and took it apart.
It is stopping the ink from coming into the sub tank from the cartridge. It's not plugged, I can see that its function is to open and close ink flow.
Does the printer need to be turned on to allow ink flow?
If so, I just need to find a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.