Recent content by sha

Sounds like you have broken plastic tray that holds cartridges. When you remove left cover on the back you have plastic that hold CMYK cartridges and can be unlocked to service machine. If this is broken chips on the cartridge are not connected to chip reader. Most definitely you font need to...

It is not a user replaceable part because you need to dismantle complete service station. Some of us know how to do it, some not and it is a dirty job. I suggest to replace SMK3 rather then just reset counter. If you reset without replacing this will happen eventually: 1. The fan that is in...

For the problem with the line in feed direction: Check encoder strip for dirt or scratches at the position of the line. Problem with the cartridges lights is normal, JV33 always using only one cartridge of each color to print. If you remove cartridge that is in use machine will switch on second...

Replace firewire card on PC, that board is probably causing JV3 IO board to burn

When dried acetone leave very fine powder inside of the head. Better not test your luck with acetone... Solution is probably cap replacement. Good luck

ST model is not included in Mimaki driver 3.0 but you can try and in Fine cut plotter setup select "other CG" since there also there is no ST model. Good luck

Ask you Mimaki dealer to get you factory parameters for your serial number. Upload it to CG-FX it will solve your problem, if not your main PCB is gone.

JV3-160SP wont work with Rasterlink 5. Only Rasterlink 3 Pro with the dongle have driver for JV3.

On Mainboard. It is a white fuse with copper contacts. Use Voltmeter to find which one is blown replace it and that's it. (you can find that fuse locally)

Main switch power ON wait to see JV33 on display, then press REMOTE.

Replace flat cables from slider PCB to Print head.

There is a two possible solution to your problem: 1. In Setup >Type 1-4> Feed Speed Level -Set this option to 70% This will smooth the feed movement. This option only works with uni directional printing. 2. CJV printer have very strange material on pre-heater and dryer surface. It sometimes...

There is a easier way. First make file in Corel as you do and send it to Rasterlink using Finecut. Make necessary adjustments in Rasterlink: Profile, layout... then return to main Rasterlink screen. In a Job list in Rasterlink at the right side you will see "Print count" section, click on it...

No, but I have noticed that during media detection machine detect right and left edge of the material but width on the display is different for 10 inches and print is shifted to the left for that 10 in. I have replaced so far: Media detection sensor, Encoder strip and Encoder reader. Thanks...

On L25500 and L26500 you can see usage and maintenance history using web server. Unfortunately you can't see if previous owner did a good lubrication maintenance (lubricating rail and replacing felts) This can lead to wear of carriage, carriage belt and scan motor... On machine 2 years old you...