Recent content by Steven.Cao

The printer works fine so far after switching the motor and cleaning the strip and encoder. All the parts are not new, I guess the issue may happen very soon.

the print is not square, when i lose the tension screw a bit, the print seems ok now. is the motor going to die?

air blow?

the printer stops and shows error code 42:03 and paper jam code during the print. There is a big bang sound and the carriage is in the home position when the error code shows. as you can see, there is an issue with the print as well. I cleaned the encoder strip and switched another motor from...

I would do it if I had a backup pump or tube. my skill set is not good enough to clean it and keep it working after cleaning :(

Does it have to be a completely new 3L OP cartridge? what is the reason please?

purged the air out as per menu instructions. use the new 3L cartridge, the printer worked well for 1-2 filling circles, then the printer showed OP ink not pumping, and asked me to massage the ink bag. the pump is not new, from another printer. how is the OP PIP messed up? it feels like the OP...

The L570 keeps emptying the OP intermediate tank. first It reminds me to massage the ink bag to force fill. after a few force fills, the printer will empty the OP intermediate tank. then I have to replace the 750ml OP ink. also the printer keeps showing the 3L OP cartridge is out of ink after...

I installed a used pump and replaced a new OP intermediate tank in November. The printer worked well in Nov and Dec, probably 1-2L OP ink, now there is only 0.47L left in the OP intermediate tank. the printer doesn't show how much ink is left in the OP 3L tank. I guess 0.5-1L in OP 3L tank...

Any way to test if Upper ISS PCA?

like you suggest, I swap the fans, the faults move from 18.10:10 to18.20:10 error. so it must be the faulty top fan?

The L570 worked fine before Xmas. However it showed 18.10:10 error anytime when I tried to print today. power off/on doesn't solve the problem. According to the menu, it is the top extraction/condenser fan. I can activate the top fan in the curing menu and hear it running. When I removed and...

1.9 SE 59.2:00 recovery failed. it showed System error not found,

first time to have this error. where to find the force the backup nvm please?

There was a M broken bag in L360 before Xmas and ink leaking from printhead rubber Nozzle area. The printer powered off while waiting for the new parts. The 2x power cables were disconnected. I replaced the new 2x ISS board and PIP and nozzle today then powered it on, but received error...