Recent content by TinFoilHat

B2 Signs

Try setting up an account at Gemini letters or B2 signs!

Yes, setting up your first few contour cuts with them can prove to be a little tedious. There are how to videos on their website that will walk you through it.

What would y’all charge to install something like this? I would probably be around 225-275

Yeah, about one hour for someone with experience. Beginner level probably at least two hours.

I have a contracted installer who is retiring, and I am now trying to find a new person to sub some work out to. Most orders are South DFW Metroplex with some up North around Denton. Would yall be able to send me any sub-contractors, and/or would you be open to outsourcing some of the jobs...

We often just use our drops from the sheet and tape them on the wall and then just use that as the template for space and leveling.

We typically do next day rush charges additional $50 +30% of the whole entire order excluding rush fee! We do same day for $100 minimum rush fee +50% of the order, excluding rush fee. Only for print ready artwork submitted before 1 PM. Seems to work for us!

Yeah, I have an account with them and have done some estimates from them, but I seem never to get jobs approved, lol. Thanks for the feed back.

Damn, Gino, I always see you flaming people's asses on here. Lol, now I am on the other end of the flame. Yeah, you bring up a good point on the reputation plus code and I might need to reconsider the job when you say it like that. Just in the past I have not had problems with the ACM on sheet...

In my opinion, it is better to get a job than not to get a job if disclaimers are made and signed. Plus this company rebrands like every 3 years at this rate lol. Yeah, I think I will try to sell them the 6mm at least since it is not too much more, and the letters would be as sturdy as possible...

Ahh, so those pads on the combo studs act at the spacer and tensioner when glued to the outside of the building to avoid going in the backside to nut it up?!

Tell me about it lol. everyone wants the cheap option and do screwed ACM instead of stud AL. I am I have a lot of my ACM letters and cut out logos still going strong 4-5 years later like this one.

Most customers do not want to pay the price point for the stud-mounted letters and would instead opt for paint-matched self-tappers on the raised ribs. I am curious, though, how I would secure stud-mounted letters on corrugated metal if I do not have access to the back side of the wall to attach...

What are your thoughts on my job setup? We have done these in the past but for smaller letters and wanted some opinions or options of what yall have done. JOB 1 6mm Aluminum Composite CNC Cut Letters with Maroon Cast Vinyl Overlay Total Size 420" x 103" 48" x 45" "Logo" 335" x 47" "BETAFENCE"...