Search results

Hi, I have an Encad 850, when running solids you can just slightly notice an area about 50mm wide, about 300mm in (from the service station side) where the ink is slightly lighter, on a panel drop this appears as a fainter area of ink down the print, but it is ever so faint - almost...

Hi, I bought some new bushes for the carriage assembly (6 in total), the carriage was cleaned and no lubricant was near the bushes, once installed and after about 5/10 minutes printing the bushes start to 'hum' slightly- which is obviously some form of vibration/friction. I can spray silicon...

Sorry, wrong forum, now moved to Misc Printers.

We have a chip decoder on the right ribbon trailing cable connector on the main board (as per instructions), the chip decoder feels a tight fit, when you push down the small plastic 'grippers' that hold the ribbon (or in our case chip decoder) you have to push hard to get them to clamp down. At...

Hi, I have an Encad 850 running with CMYK Encad Genuine GX inks, I am considering changing to a non Encad Pigmented Ink - could anyone advise if I am likely to experience any new issues running, ie carts die earlier, prints harder to dry ? I assume the light fastness is much better, but at the...

Hi I have been asking about 'channels' supported on printers, and if printers with 8 head capability can support CMYKLcLmOG, the thread is here: http://www.signs101.com/forums/showthread.php?t=92427 I am curious to know how the Lc Lm channels are handled, OG are separate primary colours...

Hi, I have been looking for an 8 colour Pigment machine, and Rolands FJ600 is one, albiet a little old. We produce exhibition backdrops, walls tiled on 1.0x2.4mt drops. Our old Thermal Encad 850, whilst very reliable lacks the consistency of Peizo technology. I dont think we need solvent at...