Search results

ok great i am working right now i can give you step by step instructions later this afternoon what we are going to do is CHANGE THE ADDRESS OF THE PRINTER TO 192.168.2.40 subnet stays at 255.255.255.0 ON THE COMPUTER we will change the ip address of the RJ45 ethernet port to 192.168.2.20...

ok. but please that is an ENTIRELY different setup if you are not going to answer questions, NO ONE can get you connected properly twenty replies ago i asked you to plug the printer into the router if i suggest something and you do not want to do it. just post NO we have 2 choices. move the...

did you plug the cable from your printer into a port on the router? did you set the printer to 192.168.1.40 & the subnet mask to 255.255.255.0 you can set the gateway to 192.168.1.1 but that step is not necessary power off and back on BOTH THE PRINTER &THE LAPTOP you should be able to ping...

its like a phone number. ANY NUMBER in the .2-253 range THAT IS NOT USED BY ANOTHER DEVICE will work IT SIMPLY HAS TO BE THE SAME IN THE RIP SETUP & THE PRINTER have you tried to ping the number 192.168.1,40 or whatever? there is no point to wasting time trying other numbers. set it the...

I have done this thousands of times but he is not posting results makes it kind of a challenge he gets to internet on wireless and was plugging in a Ethernet between an Unconfigured rj45 Ethernet and the printer IF he plugged the other end of the cable into the router AND changed the ip on...

so, from the laptop open a command prompt again <cmd> type ping 192.168.1.1 this is your gateway, the way out to the internet press enter and you should see then type ping 192.168.1.40 press enter you should also see 4 replies if yes you have communication with the printer's ip next open...

MOST but not all modern network cards autonegotiate. meaning you can hook up directly with a cable, instead of using a switch what he is doing is the same thing, his router serves the same purpose i have been networking printing equipment since the late 1980's (before networking was built...

If you are getting to internet on wifi give BOTH SETS OF NUMBERS If there are 2 sets

Ok

yes, lets post a temp and humidity

we need to know if this is the pc you are conversing with, before we change anything. your printer does not need a gateway unless you are accepting print jobs from the internet. IT DOES need a subnet mask.

NO DOUBT this can not possibly work. i still need to see what the computer settings are, BUT there is nothing you could put in on the pc to connect to that (1) post the ip settings for the pc hold down the "windows key" and tap the letter r (windows key is the one with the microsoft flat to...

stupid question, do you have a roll of media loaded? you need to & have run setup. if you do a cleaning, for example & leave at that screen, flexi will not "open port"

please post the ip, subnet and gateway of both the printer and the pc you have the software installed on normally this becomes an issue when you move a printer from one office to another or if the cable company changes a piece of equipment you will see something along the lines of...

zero nine have something similar?

i am the first to admit i am more comfortable fixing the printer or plotter when it doesn't work, than producing signs with it, BUT, why are the crop marks always FACING THE WRONG WAY. if you cut on one axis, the second crop mark is on the piece you throw away unless it is a trick question, the...

it will raise pressure in the pipe. STILL vastly better off with bigger fan even with a smaller pipe

when someone mentions COPILOT i always say it's like bing, only more so. whether that is a compliment or a warning is up to you

that is a 1204 GA can it still print the pre-grommeted banners from mutoh (if they still make them)?

i am not familiar with your unit, but, i wonder if it is waiting to "cool down" the spindle & possibly has a bad sensor or thermistor & is not sensing the cooling off effect