Search results

If ya looking for such an advise, my advise would be not to get your hand into the machine. Don't ruin it. Find a local FSE.

It depends. If I'd be you, I'd pay a visit to some local dealer and spend a while in the showroom, ofc having your preferable media and desired print files with you. After all, u r the one who decides in the end....

Not at all. Vp is old one based on dx4

Had absolutely the same situation recently in my 30610. Lost one C and one M within two weeks so replaced the head in the end.

Agreed. Lifetime cycle is the head is about 20k.sqm or 1.5y

For real? What actually causes it? I have repaired about hundred mainboards till now and never had a chance NOT TO succeed. All the problems are always the same - HV cascade or, at most, Epson drivers what happens pretty rearly. 1 hour with some regular soldering and measuring devices in hands...

try it several times and compare the results

Service menu - print menu - linear encoder

sure thing you can. You can even kinda complete Ink fill manually. Go to service menu and manually choose relevant ink set in Change ink type menu.

Not all the 6 but at least one related to encoder, 5V power supply and probably HV. Althou I'd actually replace em all as they tend to wear out about once in 5 years. For the diagnostic purposes go to the service menu and perform Linear. check

Ribbons (FFCs) between 100% headboard and carriage board.

VS is cool, nothing more to add here.

It's a different story. That series doesn't even have Poland Intelligent Pass Control feature and other modern Roland tricks. Anyways.... Go buy EJ and pass on XF.

Bwahaha, one of the most ridiculous and outdated UIs on the market along with chinese maintop rip and other worthless stuff :roflmao:

My advice is to read my messages more precisely https://www.signs101.com/threads/new-truvis-vg-print-colors.171991/post-1600911 https://www.signs101.com/threads/new-truvis-vg-print-colors.171991/post-1600897

in this case TS will have to convert printer back to 4c and then back once again to 8c )))))easy pass

I didn't say that mate )))) rather wonder about other's knowledge

as easy as get back to 4 colors model makes no sense to have 8 colors installed and simulate 4 colors prints.... althou maybe yeah, in some cases it does. there should be an option to choose the print mode so you can decide either you wanna use extra colors while printing or not so basically...

not really necessary unless they use 3rd party inks. lol, depends on the rendering intent using either of colormetric intents - yep, possible enough using perceptual or saturation - impossible at all i pretty much believe that previous jobs were done with perceptual intent (standard settings)...

anyways, where did you get the PH from?