Search results

DIVERSIFIED DISPLAY PRODUCTS IN HILLSIDE NJ...

99% of the time its heat. If you are using a canned profile, More than likely the heat is too high. Heat rises taking your banner with it. Start 215-218 degrees and adjust from there

solid fields of dark blues...increase pass mode and make sure rail is clean and oiled...

to y knowledge only photoshop and illustrator can be used for setting up cutcontour layers....if you are using onyx...use layout tab in lieu of job editor and you can set up variable data if all of your test is in csv form

I'm confused...never had to mess with a profile until now...Does that mean you have never created a profile? Linearized or calibrated a canned profile? If so, why did you buy this printer? You could have saved yourself money and touch a 315 or a 335. You changed tour ecosystem by upgrading your...

No relationships with a local printer? Everyone loves to feed the beast...then one day the beast eats you...

You can run in single head mode to buy yourself some time on troubleshooting the defective head. if you call Epson with an Ethernet issue..they want to start your device with a new head.

Start with sensor and encoder..because of the age of the printer..that will tell you if u need the motor

Your blacks look greenish? Do you build your files in cmyk or rgb? I’m guessing cmyk. I always work in rgb, the rip will convert everything to cmyk. Running a color calibration on your 335 should resolve that. The other thing to look at is your build of black. You don’t need anything more than...

...40k is all I need to know that's a lot of money for one unit to end up printing banners

first version of the TruVis was a nightmare...the resolution of the heads is less than the competitors...for what you are doing...go with an epson s40 plus a summa vinyl cutter with tangential blade...same cost as the tru vis

I have vector magic...works 60% of the time...when in doubt use vectorize now...cheap and quick turnaround

I demo the Colex recently...its pretty solid. I was impressed with their manufacturing facility and their next day EOT repair return policy. Summa takes 2-3 months. I have a firm working/service knowledge of the Summa and I'm in the market. Colex actually has a licensed version of the software...

I'm not sure what true cmyk gets you either except a smaller color gamut. If you need a cmyk only profile, you can create one onboard with a hp l365 or 560. Or better yet, buy 2 epson s80's with an Ione color meter for the same price as the Ricoh

Epson S80 is a better decision. You could buy 2 at that price. The Richo has not had a good track record...if you need to go latex, stick with HP.

usually caused by vibration across the rail with these printers. the 700/750 are worse because they are wider. Things to check scan axis motor could have black dust building up inside from bushings wearing down...easy to check. Carriage rail could be dirty or not oiled...too obvious for it to...

If you bought early 2018 then yes...you may have had issues...there have been 4-5 firmware releases since then....no different then when the latex 360 could not print red....fixed within a few days with a firmware update. I put the R in this July...could not be happier....I have had 1 major...

stay away from Oki...service is terrible...and the Ricoh latex is not ready for prime time yet...

just tape directly...no need to wast money on the paper roll. There is plenty of clearance to do this on the fly without stopping the printer...

id start by making sure your carriage rail is oiled to make sure its not static...then look to head data cables....