Search results

Thank you! I will definitely check that out.

I do have an HP that I use for some but this was printed on our Epson S80600. I noticed this on these windows from the epson and I just did some from the HP that were the same.

Thank you! I just wanted to make sure it wasn't something I was doing wrong on installing those.

I just did an install on some windows using Sihl value line 3215 80/20 perf and when you look at it from certain angles you can see marks in different areas. This is my first time using this material but is that common with this material or is there something I should have done differently on...

I have a latex 335 that we have been using for years with no problems and now for some reason all of a sudden on this briteline vinyl we have been using for years with the same profile as always our prints are coming out as shown in the attached image. I did a test print and it seems to be...

does anyone happen to know this font? I know I have seen it before but can't remember what it was.

Does anyone happen to know what font this is?

Does anyone happen to know what font this is?

Does anyone happen to know what font this is?

The tech never installed that on our computer when we got the printer over a year ago. I have tried downloading the epson edge and it always says it is complete and I can open it at the shortcut but there is never a shortcut or anything for me to open when I finish the installation.

I have already talked to substance. They only have profiles for onyx. I am running flexi

Does anyone know of any good profiles for the S80600 to use with Flexi? When we had our printer installed the tech just went with a basic 3m profile and I haven't found too much other than onyx profiles and wanted to try something different with our substance media. I know we can get better...

Is anyone familiar with the font used in this picture?

Does anyone happen to know the font that is used here?

Does anyone know what would cause this? When printing it sounds like the motor is making a different noise and the foil just seems to stick along the vinyl and not roll up into the other roll and just causes it to break after a few inches of printing.

Our tech just showed up finally and it looks like one of the heads they just put in is bad. We were printing on single head mode and it stopped doing it.

It is more noticeable the lighter the grey is. On the darker grey it can be seen but just barely in some spots not nearly like it is with this.

I have already printed multiple jobs with new files and it does this exact same thing for just the light grey.

Yes, these are the same ink that was in the machine before the head swap. Yes even after doing some cleanings it is still the same. I have been doing tests with the same print file and it does not have any pattern. One print it will show up in certain spots and the next it will be in other...

So I just sent the images over to the vinyl supplier and they are saying it looks like it could be static dissipation? Has anyone ever dealt with that or think its likely?