Search results

Anyone know what sequence of buttons I push to get this thing back to normal?

same here.

I'm not sure what I did but my Falcon 48 will not let me advance the roll with the buttons. It also is telling me to remove the media after each print, also not letting me use the buttons to advance the media. I must have hit a button or a series of buttons that put it into this mode...

I use Rapid Tac II instead of the Rapid Tac. No particular reason except it works good.

That works. Thanks a BUNCH!

Any Idea on this? Thanks in advance. JD

Any Idea? I can't pin point it. ALL Help Is Very much Appreciated. Thanks in Advance.

I want to wrap my truck. It's my everyday driver as well as shop vehicle (2001 Dodge Ram 1500) It has some rust spots on the side of bed and also starting on the bottoms of the doors. No cancer spots or anything that has rusted through yet. 1. This would be my first wrap. I have been...

BINGO!!!! THANKS TO EVERYONE FOR ALL THE GREAT HELP. :notworthy:

I missed it the when I went through them the first time. Just downloaded it. Should do the trick.

Thanks for all the suggestions and help, but I'm not sure if I made myself clear in the OP. These are already printed, in hand, and ready to stick. So this is the exact design I need. Thanks again to everyone for all the help and suggestions. Time's up on my end and just going to hand cut them.

I just need the outline. The problem is it comes out distorted when I trace it. Too much on one side too little on another. If I can find the file, I'll just buy it and charge the customer for it.

Anyone know where I can find the outline for this shield? I need to put 4 of these on a couple of firetrucks next week. They were purchased on e-bay by the fire dept. (actually I purchased them at their request). The company said they would send me the outline to cut an overlay (I've gotten...

+1 fba

Thanks again Fred. Much Appreciated!

Any Ideas on the Silver Numbers and Letters? Thanks in advance. JD

Just wondering if anyone here has used the Darkjet Solvent Printable Media from SW. I have a Falcon Outdoor and I'm needing to know what level to output the inks on it. They told me 100% would be too much but can't give a good answer as to what is a good percentage. The only reason I a...

Looks good. My wife is on me about doing stones too. What program are you using for cutting the templates, and what size stones are you using?

+1 What happens if you run 3 test prints back to back? Does it clear up by the last one and start printing correctly? I had that happen before and ultimately the sponges on the capping station were swelled up so I ended up removing them until I got a new capping station and actually ran it...

If you are printing a spot color orange, try mixing the colors to your liking in the Ink Limits Settings in the Production Manager. Just be sure and write down the settings some where when you find that Unicorn Orange.