Search results

just got a new Jack Ripper catalogue and saw them in there.

never heard of it

Sprinter come in all different sizes. Not sure about Spriters. might check mr clipart for a template

typical day morining coffee afternoon Mt Dew After hours Natural Light

I have done a couple and used 3M180cv2 with no problems. I am sure the v3 will work the same. No outgas problems and was applied within a weak of painting. I have a phototex sample I printed last week I am going to do some testing on.

dont do many here as the party store up the road will do 30" x 10' banners for $45. Thats right 10 FOOT for $45

Sent him some last week. Got more for him next week.

Here we only use 651 on race cars, Coroplast, cheap window decals and occasionally on banners(we print most banners). Cast on Everything that needs to last more than a year.

why didnt you go over the bed rail

print it roll it back up flip roll print other side

I use parallels to run flexi. Only problem I have is with the mac not finding shared folders on the other 2 pc I have when parallels is running. Not sure if it is a parallels issue or something else. Maybe I just dont have something set up right.

It may not have anything to do with it but grimco told me I had to have xp pro when I bought my mimaki

what was the process for dealing with the cowl scoop. I am assuming you made a paper template, took a picture and redrew them and ran it through the cutter. I may have a camaro and a mustang to do in the next couple weeks. Any insight is appreciated.

this question has been ask multiple times. try using the search feature

I take the shipping is a bit excessive. How do there prices compare to oem. Do their parts fit and work like original.

I got it printing again but I pretty much decided I am going to change the pumps, capping stations, and dampers. I dont have time for this thing to go down again. Any suggestions on where to but these parts and what I should expect to pay. I will most likely buy from grimco unless theres a...

we dont cuss him so much anymore. We finally figured out how to use it. I have ran 54" prints up to 30' long through it. Even longer 30" prints. As long as you get it started straight and have the tension right your usually good to go. The biggest draw back is you almost have to have two...

zmat. you must not have used enough duct tape and beer.

we changed the one on mine a year or so ago. it took two guys, alot of soapy water, an air compressor, some duct tape, and a couple beers. its a bear to get it started on the shaft but once it starts it goes right on.

I pulled ink through the 2 empty yellow dampers and one yellow cyan with a syringe and got my test print back and the air out of the lines. I am in the middle of adjusting the capping station now. Once thats done I am going to do a fill up ink and see if the dampers stay full. But I still...