Search results

Hi all, I got an inquiry to do a short run packaging boxes and cake boxes. The cake boxes are not as thick as the packaging boxes. I only have an HP Latex 335. I'm not sure if there is anything (cardboard) that I can load into the hp latex directly. My idea is to mount vinyl to cardboard and...

Hi all, Been searching the forum for this question but couldn't find one. Only about car wrap edge lifting. Perhaps it's a beginner question. I've been doing full print (edge to edge) and mounting it to corrugated/acm panel but got a lot of edge lift/peel. Especially from cold weather to hot...

Hi all, I'm wondering if it's possible to lay one summa barcode next to each other (side by side). I'm trying to improve the accuracy over very small stickers. Instead of copying them individually to hundreds (not accurate over certain length). I prefer to make them as a set then copy the set...

Hi all, Wondering where can I find the overcut on flexi ? It seem to be missing after the version sp5p4 update? I tried the offset but got different result from the previous overcut. thank you in advance.

Hi all, Got questions regarding flexi flex cut and summa. Been using the contour cut for a while but never really used the flexcut. So this is my first try. Setup the file in illustrator, created 2 spot colours, named CutContour and PerfCutContour. Also separate the curves into 2 layers. Flexi...

Hi all, I'm having a little problem. My summa S160D is a little bit off, it's always cutting just slightly above the print/design, most of the time. It's not like terribly off, only about 0.5mm. However, I'm doing 2 cm in diameter label so 0.5 mm is quite noticeable especially circle with...

Hi all, I have a neolt 250 manual trimmer. I misplaced the cutter head screw, roller and springs. Contacted a few seller, they offered me to get the whole cutter head assembly, which is not cheap (around $300). I got the exploded diagram and part numbers. Anyone know where can get those...

Hi all, Have a question here. I just purchased a new HP latex and it came with flexi (the distributor upgraded it to premium one so it can do print and cut). I managed to do print and cut just fine. However, I got difficulty doing direct cut to cut colored vinyl. Flexi always want to find...

Hi all, I just got a second hand summa driver S class and downloaded the usb driver from summa's site. I successfully installed the driver onto win 7. However, windows 7 said it's not digitally signed and didn't allow the driver to run. This issue made the plotter not detected and can't be...

Hi all, I'm Will from Melbourne, Australia. Used to be a 3D modeller/animator/visualiser then into graphic design and illustration. Got a plotter 9 years ago then slowly work from there. Now I'm operating a small roland selling my own illustration and design from home. I'm a bit shy but...