Search results

Tweedy Bird got a good tan :p

Thanks, I tried everything, scan slow, scan fast a i1 a i1 pro 2 and i keep getting the same message, but i can scan color when you go into the spot color settings I would really like to fix this problem, but Roland has been no help :(( Thanks

Yap hehe What about your self ?? I leveled off the machine and set the heads to 0.070" seams a bit better You having a hard time with the heat we been getting ???

Would anyone know what is the correct head high on a VP-540i ??? From the top of the bed to the bottom of the head my local dealer said its 1.1mm and seams tight at 1.1mm the carriage hits the whipper cover Thanks Biggs

Hi everyone I have a Vp-540i with third party ink and was curious what is to hot to print, it was reading about 85oF ,90oF in the service mode menu, My magenta is looking like there is over spray on the edges and making some white letters look pink, and it seams like my yellow was plunging...

I looked at my A & B under magnification only 10X but almost seams like B is finer but i bet they are probably the same crap, but the rubber seal on B is smaller then A so that probably means a better seal I have some inline filter right after the ink carriages The DX4 print head has a filter in...

They are both Chinese S#$T

Hi there Just curious see what people thing / opinion on what damper to use A or B I have both and not sure what to use, I like A with the bigger filter but B looks more OEM and had the double metallic thing inside What do you think ??? Thanks Biggs

You are right, lucky for me i found a dealer with good used ones for 10$ cnd each that about 0.12$ us hehe

Yap it sucked big time, i blown a brand new head f$%^ing around that them crappy parts :( i must have gotten ink in it

Hello Everyone Just curious to see if any one have tried some of the DX4 manifold from china ?? I got a few and it seams like they are sucking air from somewhere, i put new cap tops and new dampers, everything was working fine until i broke the cyan manifold then broke the black one too, i...

it looks like both are 180 DPI so i would say yes it would work If you look on page 3-65 in your service manual it shows step by step how to change it and on page 4-34 it shows you how to set it up

I Can reprogram ink chips. PM me if you like

I think Gino is probably Right but it don't hurt to clean all the encoders, then you know for sure its not that.

Check that out, let me know how you make out. I am thinking the setting from your old board might have not taken in the new board. I see your in Toronto, you come up to Sudbury often ?? hehe

Very Easy, Take the big long grey cover off there are a screw at the end were the carage parks and at the other end a screw with a spring Mine is all apart, in the process of restoring it, hehe I will go take pictures,

That's a new one i never seen hehe Did you try to clean the encoder wheel too ?? What is look like When you do the test print to align the print heads ???

It could be, mine dose it the odd time, i have to take it apart and see whats up with it

I have done a few of them, i assume you already have the peck tool ?? 1- read everything with the peck tool 2- change board 3- load everything with the peck tool 4- rock and roll Just take your time, lots of notes, pretty much all the plugs can only go in one place one way

Try to do a limite intitalize procedure I have vp-540 not sure if its the same but i have a similar problem, the little carage shaft lock thing dont always work, its on my list of thihgs to do