Search results

if you are cutting without laminating, it doen't matter what brand of vinyl you use it will always curl up, BUT if you cut the vinyl where there is no ink the vinyl will cut fine, if you can get away wtih leaving 1/16" outline around your graphics thats the best way to avoid the curl up issue

when ever you get all ligths flashing all you need to do is pullout and reinsert the cartridges one by one with the machine power on, and it will take care of that problem

Thank you for your responses, but the sign is for a hotel i forgot to provide the dimension the sign is only 4.5" x 6.5" and around here when hotels get remodel the contractors take care of all the signage with online companies I can't really go to the landlord

I need some help finding a supplier for this kind of sign the material looks like marble the trim and logo looks like metal two of the signs were damaged and the customer does not remember where they got them from any help will be greatly appreciated

on a different brand of laminator when that happened to me the pulleys inside the gearbox were worned out, I took it apart look at motor type and gearbox replace it in about 15 minutes

this is how I cut aluminum on my homemade set up I use a piece of blue styrofoam between the table and aluminum. why styrofoam and not a scrap of sintra because sinrta is hard and when your are cutting at such low speeds it tends ot melt and stick to the bit attached the blue foam to table and...

I want to thank you all for your responses, this gives me some ideas as to how to handle this kind of jobs, and just this morning somebody left me a message last friday after I left about wanting to get some signs done and of course they need it me to go over to their building and match what...

what to do about small jobs? I've been doing signs on my own for about 5 yrs. now and every now and them I get a phone call about someone needing a bid for some signs and this is how the conversation goes. my name is such and such and we need to ger a bid for signs and so on, so we set up a...

thanks, I will call metal shops around here and see if they can do them

hi, Everybody does anybody knows where I can this kind of blanks, I was looking for something about 24" x 36" is made out aluminum .063 hollow back it also has welded studs on back for mounting thanks in advance

:thankyou:

hi, everyone I need some help iding this font, i looked thru my system and don't have anything close to it, thanks in advance

Signs 101 Network RegistryIn what country are you located? United States In what state or province are you located? Colorado In what city or town are you located? Carbondale What large city is nearest you? Glenwood Springs Check all items that apply to your listingInstallations (Basic...

i did noticed and started to get suspicious about really having a full 150' roll, so this is what I did, my laminator only holds a roll 29" wide and the overlaminate comes in a 30" roll so i have to cutoff 1" from the roll to make it fit, I measured that 1" I cutoff and the roll was actually...

have you checked your cutting strip? mine wasn't cutting smooth of finishing the cuts once I replace that, problem went away

century bold

let's go down the road of the what ifs, do you at least get a "found new hardware" message when you connect the printer to the computer? if yes, them you are safe, but if you don't then you might have a bad mainboard, if you have flexisign 7 or higher you can still run the printer from flexi...

well if you are lucky you will get to match, but 90% of the time they never match, like someone posted before match the text and all the critical areas

actually the correct way is: poner carro en neutral no pise el freno

thank you, for all your help