Search results

We did one using roll styrene on our Zund cutter. It had bridges for the insides of the letters, looked stupid IMO, but I think it will work for the customer. I don't know how they stuck it to the surface of their vehicles though. I didn't have any suggestions for them on that one.

I'm not familiar with heat welding, can you give me a quick explanation. My boss says we did the whole job here, in which case, we would not have the ability to do that, unless it is something as simple as running the banners through our laminator with the heat turned on, which we are attempting...

We buy pre-cut 18x24 blanks, lay them 10 up on our flatbed, set the copies and push start. We can run around 50 per hour.

Hi all, We are making banners using Fischer Textiles SI6000 Coated Poly Duck and the banner tape that we are using will not hold. This is a repeat of a job done 2 years ago, only problem is that none of us were here when it was produced and we don't know how they got the banner tape to adhere...

I know VHB rocks, I used it a ton at my last job, but the customer (washington state liquor board) is extremely discerning and they want the letters to be 100% flush mount; does VHB come in super thin?? We don't want any tape showing and I know that VHB isn't clear. We are hoping that a glue...

Been a while since I've posted but I have a question. We have some really small 3mm sintra letters we need to afix to 3mm dibond. The letters are too small for mechanical fasteners and standard mounting adhesive is not strong enough to do the trick (tried and they typically fall off). Is there...

Yes Grandpa sold the house and moved to Alma, NE to be closer to Barb's family. I haven't seen him in a while, but I understand that he is doing quite well. Next time I talk with him, I'll ask about your dad.

P-Burg huh...my grandpa lived there nearly all his life, I'm sure you've heard of Max Porter. A.K.A No Thumb. Anyways, glad to see that something is going on there, I spent many a childhood summer in P-Burg. Welcome to the forums and good luck!

Welcome from inside Kansas City!

I think your employers should file a suit if the dealer doesn't honor the warranty. I also think that the next time you (or anyone) receive a printer or other equipment that has damaged sensors, you should not accept the shipment and have it sent back to its origin. I'm sorry to hear that you...

we ran into this problem when running Versaworks and i found a solution that worked for us on the Roland User Forums (they have tons of threads on green grays). If you are using versaworks, do the following and then test to see if a difference has been made. Quality Settings tab go to Color...

See bold above, again, sorry for the delay in posting.

hi rick, i've printed on a few textures of Korographics wallpaper and I had to do many things to get it to work. No heat on platen or our other heater. Did a Bi-Directional Correction adjustment for the material. Head height on high due to head strikes caused by wavy material and i also fed out...

Nice work all, it was so hard to choose.

I run a Seal Image 600 and I always laminate my graphics before mounting them. That's the way I was taught, seems to work out fine. I often end up applying large vinyl prints on substrates like sintra or styrene and it would be too difficult to apply without laminating first, to give the graphic...

ol' whiteman...my stepbro was stationed there for a while and yes it is what you say it is. bbq capital of the world imo. Thanks to everyone for the warm welcomes ! :thumb: