Search results

Illy and PS newbie here. Anyone have any good resources on how to create the effect shown here on the "Champion"?? I see in this order; a general top to bottom gradient, a black layer, background with a reverse bottom to top gradient then a black layer behind that How do you do the light spots...

My "find my font" trial just expired and I need a quickie please. looking for the "Champion"

Only in Portland :)

WHOOOO HOOOO!!! So I had checked the dampers earlier and everything looked fine, so I ended up flushing the pump to that set of heads. I didn't see any obvious blockages come out in my bag but what I did notice was that the waste tube was very constricted. I ran a new tube and fired her up...

Thanks. The lights are rated 5500 Kelvin which is direct daylight but realistically I think they are closer to 5000k. Either way our shop lights are at 6000k So I can turn the printer ones off and color match if needed.

More pics

I know there are a bunch of threads on this upgrade but I thought I would share mine. I bought the LED strip lighting (SMD 300 3528) , transformer and clip leads on Amazon from LED Wholesalers for $32 shipped. I did consider the 5050 lights as well as the SMD 600 but I am glad I didn't...

OK. I will and then will report back. THX

3rd party Bordeaux Ink.. It's been running through the machine for more than a year with Zero problems.. Until now maybe.. Visually the dampeners look fine. No bulging or sucked flat... Blockage maybe? I think I am going to order two dampeners and an S cap and start there. What other...

Well that is encouraging. I guess today is going to be an ink covered day :) Thanks for the help!

Haha! Thanks Mosh. I think I'll need a laugh once I sober up. ;)

Do you need a heat assist. No. Is a seal 54el all you need.... It's more than most people need and exactly what people want. Trust me.. It's easy to use and incredibly built. You won't be disappointed.

Hey all.. I went out in the shop this evening to run a few prints and two feet in to the print I see this huge black ink blob.. I let it print another 8 inches and saw another one! ****! Cancelled everything and ran the heads over for a look.. Here is what I found.. It's leaking pretty good...

SEAL 54EL Best $5k You'll spend

Stumptown Coffee. Today it's Indonesia Gajah Aceh (organic) But what can I say.. I live in Portland and we are all coffee snobs here.. Also beer snobs but that's after 5pm :)

is there a question in there somewhere? 4 thousand a piece.. No wiggle room.

I Finally sort of figured it out. I called Phil at Summa and he was VERY helpful. After a few failed attempts I spoke with a tech and he walked me through setting up winplot. After a successful test cut I am off and running!! Thanks SUMMA guys! (another reason to buy a summa) Turns out our...

Frank, Thanks for your input.. I'm getting the value by measuring the distance between actual registration marks on the print. I know this is the wrong way ;( Bly, I was kind of half thinking that I might need to resort to Winplot. I guess it's only one more piece of software I need to...

Frank.. To be honest I think you are right. The Summa is set up as a contour cutter properly in Wasatch. Wasatch successfully creates the marks but when I send the file to the Summa it does not prompt me to set the knife on the first mark. It just starts cutting from wherever the origin...

To all those interested I found out that the problem was that I was calculating the OPOS mark interval in CM not MM so after adjusting the parameters to 300mm instead of 30mm it read the marks perfectly. Next question is that once it's done reading the marks it sets to what I think is an...