Search results

Wow that’s harsh! But I recognize your name! lol

Yes. The first side went well freehanding it but to get the match on the other side was a fail. So a template using just vinyl and going slow. I’ll try that. I didn’t realize you could sand the edges. I used to file them until I got a burnishing tool which isn’t always perfect, if it hits a bad...

I have a one time cut to make on the alupanel for a decorative shape at the top as seen in the picture. I used a jig saw which worked fine until I did the other side using the cutout piece for a template. I would like to properly learn how to do this. I normally send them out but that’s becoming...

The right. Behind the buttons. Will try that. Thanks.

It’s a brand new roll I purchased.

Cold 30” laminator

I have been having a problem with the tension in laminating. I used the 210 without any problem laminating then switched it over to 290 and I can’t seem to get it smooth. I never changed the tension. Tried several times and wasted a lot. I switched back to 210 and it worked fine. I’m not sure...

It does look different. The 101.

Thank you!

Does anyone recognize this font? Thanks!!

Yes Orajet. Now do you use 290 laminate with it? I usually do flat areas. But I do apply over rivets now and then.

I use cast for vehicles and anything outside. I did use the 3m knifeless tape which didn’t go well. Lol. It’s been a while since I used it. Does it get old? I didn’t find that it has a nice clean cut. I need more practise too! I did try heat but i ended up scraping that piece. I’m not fond of...

Shows the sides, another splice

I am putting a 2-2.5” stripe on a truck boxes where it meets the truck liner so right at the top. I always find it hard to make any slight curve with a stripe this wide and trying not to have a splice. What is the best way to make that curve at the end that goes around to the tailgate? I precut...

I have to put vinyl on a new snow machine windshield. I don’t do wraps so this is all new to me. I plan on using black cast vinyl. I have never done this and usually turn away jobs like this or try it and it fails. I hate saying no when I have done other jobs for them. What’s the best way to...

Great thanks. I wondered if the blade would melt it. I’ll try it!

I have to cut against the flutes of 10mm coroplast. What is the best way to do that? Couldn’t seem to find any previous posts on this. Thanks.

That’s exactly what happened. Now I understand why. I was indoors but it was quite warm out.

It went better than I thought it would. Took a bit of advice from all of you. Putting it on dry, tenting the rivets and Also trying to ignore the rivets worked best. Also a pin hole under the rivets was necessary too. Where I went Wrong on the last trailer I did was applying it wet. A few...

The good thing is I don’t have transfer tape on. It is just 4 straight panels 28” x 78” x2. Thanks for all the responses!