• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Search results

  1. Easy? Font ID...

    Hi. I should know this one...it escapes me.
  2. Need Help Buying a used upgraded Versacamm SP300v - what to look out for ?

    The machine must NOT have been sitting idle for much time. They are designed to automatically pump ink through the heads on a daily basis. If it has been sitting for longer than a week without power, the heads could be compromised. Do you know what the print test looks like?
  3. Sp 300 v temp to low

    I usually do turn off the heaters when finished printing...only to save electricity. I only use the printer controls for temperature, not the versaworks settings. If I'm impatient, I can turn down the heat settings.
  4. New Guy Just Checking in from Oakville Ontario

    Rebels welcome. You should fit right in. Cheers from BC!
  5. Geometry wizards?

    HYbrid solution...? I haven't cut it out yet, but this is what I have so far. I took Gino's advice to determine some of the dimensions then using some node editing created this layout in Coreldraw. I think it still needs some tweaking. Thanks Gino.
  6. Geometry wizards?

    Hi Folks. I am tasked with applying reflective material to various sizes of traffic cones. You see them all the time with flagging crews, construction sites etc. The reflective material is wrapped around the cone (I would like to have a bit of an overlap). How do you lay this out for cutting on...
  7. versacamm sp300v dropout question

    Same machine...similar problem How does one go about "soaking" the head? Thanks. Ken
  8. Cut/plot not launching...?

    help... Help...
  9. Cut/plot not launching...?

    Hi Folks. Corel GS X5 plus Cutting Master 2 using Graphtec FC 7000. When I try to launch the cut/plot that usually opens the Cutting Master screen I get a time out error message. I've done a repair install on Draw 5 and have the newest Cutting Master 2 version. Any one else have this...
  10. Help with font please...

    Thanks. As always, thanks Fred! Cheers! Ken
  11. Help with font please...

    Hi. Can someone please identify this font? Thanks. Ken
  12. Font ID please...

    WoW ! Very fast ! Thanks. Ken
  13. Funny business names that you've done work for ..

    No photo but... Wally's Private Parts is a local supplier of used equipment and parts for the forest industry. Cheers! Ken
  14. Font ID please...

    Can anyone help with this please? The T is lower case. Thanks. Ken
  15. Newbie Here..hello everyone! A Roland SP300 Head Question?

    Hello... Hi, welcome from BC! I run an SP300 and I'm told that head replacement is beyond the scope of the average person, that a tech is required. However, the offer above from VanderJ sounds pretty good. Good luck with it and please let me know how you make out 'cause I prob should be...
  16. ever seen this before? is it legit?

    Ignore it... Sounds like a phishing expedition to me. Ken
  17. Font ID please...

    My bad.... Yeah, sorry. I've been away awhile. Thank you J. Hill! Ken
  18. New From NC

    Welcome Hi Jason. Welcome from Beautiful BC! Ken
  19. Font ID please...

    Doh ! Thanks Jill!
  20. Font ID please...

    Hi all. I feel dumb about this 'cause this is a file I created - and lost - after a computer crash. That's right...no back up for this file. Anyway, I have a repeat job to do and can't remember the name of the font or where I even acquired it. Notice the letter D with the open top and the E has...
Top