Search results

Great. Thanks. That’s what I was thinking as well.

Is a Roland SP-540V Printer/Cutter worth buying? If so what would the value of it be? I have the 300i but it would be nice to print larger especially a full 4x8 once in a while. I thought if it was cheap enough and worked well. The print test shows it may just need cleaned? Any input is...

$44 a yard in Canada

Is this an easy beginner wrap job? I see it only comes in 60” and supreme may be the only available one at the moment.

Thank you for the info! I was going to use 48” and start from the side and go around to other side. I don’t have to do the back or bottom. Then cut out doors and do them again separate unless enough film wraps the edges of the doors. Then do top separate? It’s just me so 60” would be hard to...

They will take off the doors and hinges so it will be a flat surface.

I have a 4’x8’ welded metal box with two sides that are 4’x3’w, the front with 2 doors and the top. They want it in vinyl to match their white 5th wheel trailer. I don’t do wraps but I think this should be basic, I hope! If I go with a cast wrap it will be the white it comes. I thought I could...

Thank you! It is a 13 oz double sided banner. Anything I have read the 30” has no way to change the head height. Which is weird. Yes it has printed fine in the past. I guess I’ll just keep an eye on it. Just being extra cautious with the new head!

I have a Roland sp300i and I’ve always printed on vinyl and banner and have never changed the height of the printhead. I am not even sure if I can on my printer. I just replaced the printhead and have to print on double sided 13 oz banner which I have done before but now I wonder if I need to...

I ended up getting the head replaced and it’s printing great again! Glad I kept it. How do I change the head height when printing 13oz banner? I have always used the regular height. Is there just a low and high setting? Then I should program it in which I have never used either.

I did do that then put a little cleaning solution thru too then pulled it out again. I’ll give it another try. Thanks so much!!

Ok from the black line which I did but wasn’t sure how much to pull thru. Keep pulling til I get nothing?

It ended up being a 72 hr head soak by mistake. The test print printed red where the yellow shld be so I drained the line abit with a syringe and did a few medium cleans and it’s back. Prints the black the same as before. I remember long ago I put cleaning solution thru the lines to try and save...

Thanks! Soaking as I type this. I’ve tried the 12 hr soak a few months back so I hope this works! The caps took alot of solution until it sat on top.

Doing a powerful clean on it now which I don’t normally do. I usually manual clean once a month and that’s it. Reason for this I know! It has very low hours on it as I still used vinyl more than I should have and I was afraid of it at the beginning! I think I may just fix it but here are some...

I have a Roland sp300i bought in 2010. My black printhead has needed to be replaced for a while now. Colours print good but I seem to have to clean it more often. It isn’t used everyday which is why I put off the head replacement knowing it will go again sooner than i would like. My dilemma is...

Thanks. That’s a great idea. I’ll give it a try.

Would like to know as well. I have a Roland sp300i and I was told today the parts are getting hard to replace. I need a black print head but I am sure I can still buy. They suggested upgrading machines.

The reason for reinstalling them is that they replaced all of the siding on the building.