Search results

Hi, We have the TXF-300 here. Everything is going well, our six-month acquisition. We already have five Mimaki machines here for sublimation and other printing, and I know them well. We only had one problem at the beginning, but it was a problem with the dampers, and Mimaki replaced them with a...

I already have an X-RITE measuring device that seems to be compatible, but I can't find the module to create profiles. Is there a tutorial on the web that shows how to do this? Thanks.

Hi, I want to know if i can create my own profile with Digital Factory DTF edition. I use with Mimaki TXF-300 Thank

Hi, We had this problem here. We noticed that our glue in the shaker oven wasn't cured enough. What temperature should you use to cure your glue? If there's glue left on your transfer paper, that's your problem.

Hi all, When I make several copies of the same cut in CM5, with the FCX2000, the head is not always positioned in the same place and it always moves back a few millimeters. After three copies, I have to reposition my head on the cut mark. Is there an adjustment for this function or is it a...

Hi, The printer was installed by a technician qualified by Mimaki. The company that sells us the machines are the only authorized sellers in Canada. I have had Mimaki printers for almost 20 years and I do not have this problem with other machines that do sublimation or Eco-Sol solvent...

Hi all, Since the new installation of our Mimaki TXF-300 printer, I am not satisfied with the #printing result. I have a lot of #noise about #gradients but also about certain colors. I tried the printer in unidirectional mode but the result is not much different except for a slight improvement...

Thank for reply

Hi all, How to use only 4 cartridges instead of 8 in the TPC-1000. I don't use my printer enough and the cartridges always expire without being used. My configuration is CYMK with two cartridges of each color. How connect lines? Regards.

Hi, I don't know if you have resolved this problem since then. This is because CM5 imports CM4 parameters very poorly. Simply save each parameter again in CM5 and everything should work correctly. This solution worked for me. Another thing, CM5 doesn't pause before detecting crop marks. Well, I...

Hi, I need to know how can reduce space between page or "JOB" when i set layout option in AUTOPAGE. I know i can get less space when i use nest option but i don't like this option because all job are print in queue together. I set space between JOB and COPIES to "0" but i have always a very...

I can't understand. When i put my FC8600 graphtec cutter on 20cm/s, it's go faster than my FCX2000 at 40cm/s ???? What's wrong?

Hi, I have a #FCX2000 and this one is very slow #cutting when cut a #circle. is it normal ? Thank

Hi all, Thank you for your answers, I actually created an RGB profile and I have had very good results so far when printing my images. Thank you for everything.

Hi, How do I know if my printer is an RGB or CYMK printer. When I use iProfiler software, I have a choice to make before creating my color profile. Thank

Hi, Does anyone here know where I can find a tutorial on how to remove my head from the JV300 without adjusting it. I want to do manual cleaning and it's very difficult to access. Regards,

Hi, Since updated V. 3.3 on my FC8600, the cutter move at the end of lengh job before cutting, and return on home. I have a new option like "F" for cancel it on LCD. Can i remove this option, because i spend a lot of time ? thank

May be help you. I fixed the problem. Fixed

Finally I fix the issue. In the CM5, you must have to create the registers relative to page. With version 4, it was in relation to the artwork work fine. Also I think it's very important to work by layers but not with option ALL.

Hi, Sure, i use FC8600 series V3.3