I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
I have a FMJ-1600II laminator that I have been using for 6 years now and I am having an issue recently. I use it to lay 4x8 sheets and 4x10 sheets. I use 3m IJ35c-20 with 8520 over-laminate for most jobs. The issue has been that the last 5 or so signs I have run through have come out perfect on...
Mimaki JV33160
Went to change the head last week and then the printer would not power up at all. Relays click, but nothing. So I do a ton of reading. I figure it is most likely the head fuse. And this is where the confusion starts...
From everything I can find online the head fuse is a...
Quick run down:
All of the sudden today I have RIP and Print showing registration marks, however once I send it to Production Manager there are no registration marks.
I recently had to delete the Mimaki JV33-160 from Production Manager and add it back in due to a USB issue I was having. It...
I have a FMJ-1600-II and use it for laying vinyl on large panels. It has been good for about a year and now every time I lay vinyl on a panel it has bubbles on the right half on the panel. I have tried to level the rollers as best I can by feel and it still happens.
Do anyone know what could...
O.K. I have another thread right now, but this is a totally different problem, thus a new thread.
I had a broken post heat thermistor so I ordered a new one and it got here today. I got it installed with no issues. So I boot the printer back up and go about setting the temps on pre/print/post...
Setup: JV33-160 running Mimaki ink, Flexi 12 and Production Manager.
Last Friday I had cyan dripping all over the place, badly. I take a look at the dampers and I notice the left most cyan is bulging out. I put a tiny bit of pressure on the clear cover and it squirts cleaning fluid on my hand...
So my morning has been a fun one. I figured I would share this in case anyone else ends up dead in the water.
On your JV33 printer you have two head lock screws. These are one of the weakest parts know to humankind. They are made of (as best as I can guess) compressed baby powder held together...
I have been using Flexi for years now, and I am getting back into Illustrator after being out of that world for 15 years or so. My question is: Is there a way to add shortcuts to Illustrator for the align tool? I.E. to make it so that Ctrl+NumPad 5 = center object etc...
Thanks in advance.
I have a JV-33-160 and it will only print a test print in the feed direction. I have read every manual I can find and I do not see where to change this option in the menu. It says that it is under the "Machine Setup" menu, however i cannot find it. I don't know if I need a firmware update or...
I have been fighting whit this for over a month now. My hi-speed bi-directional printing is off just a bit. See attached close up photos. So I read through my manual and I do a DROP.POS.ADJUST test. See attached pics. I adjust the numbers and the very next DROP.POS.ADJUST test print is still...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.