Search results

In relation to the OP, the issue is Signlab can't render to bitmap CMYK designs and keep them in CMYK, it changes them to RGB, to create a CMYK image I use Corel instead, then take it back into Signlab. I was just searching online to see if they had addressed this issue in Version 10 which has...

I'm using same print profiles as I always have with genuine Mimaki and other 3rd party inks so it shouldn't be those, I think it might be not enough solvent in the ink or something like that hence them not smelling like they usually do when printing.

Hello, I've switched to their inks as they manufacture it in the UK and if you use their ink they give you a mileage/3 year warranty on your print head, but I have had a lot of issues with the ink remaining tacky and even sticking to the rear of the rear of the backing sheet on the take up...

Put the cap slider in and all sorted. Bit confused by another engineer I spoke to on the phone who said when installing that slider to be careful of the metal plate at 45 deg beside capping station as if I don't screw it down again it will catch the head and ruin it, but from what I can see...

Thanks, I did try it with 1mm shim but not 100% sure if I want it to move that way or the other way and didn't see any immediate improvement, although this has been going on for a month now so might be another issue crept in now.

'I know you've put a new station in so the slider should not be worn down which is usually the cause of the offset.' I think this is what it is then isn't it, he didn't put the cap slider in and now it's offset? Looking online it looks easy enough to do, but like all these things when you are...

Guess who, another thing to point out is the engineer didn't replace the cap slider in the service as he said the one in there was ok. Hybrid Services who are main dealer for Mimaki in the UK said 'From what you are describing it looks like it needs a component further down in the capping...

I suppose, as I believe the height of the cap is adjustable, if it is high it will go further one way when raised up as the head presses on the black plastic that raises it, and if it's low it would effectively move it the other way?

It's hard to figure out which way it need to go, in my pic of the head the spring is at the front of the machine and the black lug bit at the end of the spring is on the right of the machine, but looking into where the head sits on the cap when it is parked, it looks like it needs to move to the...

Thanks for the tip, do you mean it pushes the cap over to the right a bit though?

Hello all, I have seen a similar post to my issue here https://www.signs101.com/threads/how-to-adjust-jv33-capping-station.117009/ and in that post it says you can adjust the capping station position with the control panel. It's all new after a service as is the head but since installation I've...