• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

graphtec

  1. Graphtec fc7000-75 will not cut

    Once a job is sent from Flexi to the plotter it feeds out all of the material and never cuts. It does not stop at the end of the material but rather spits it out. I have cleaned the sensors, checked connections, performed test cuts from the menu, and doe an overall cleaning. Any suggestions?

  2. Graphtec cutting inconsistencies

    Hello, I have a particular problem with an FC4100-130 cutter. When cutting the cutting paths are inconsistent and dont match from the start of the cut to the end of the cut leaving the path incomplete. In addition, when cutting text, escpecially letter "O" and "D" it will cut the center and...

  3. Looking for a dead Graphtec CE1000 or CE2000 to salvage some parts from>

    :omg2: Does anyone have or know of a broken Graphtec CE1000 or CE2000 roll plotter that might have a usable control panel LCD? Or a company that deals in used plotter parts? Or even a new LCD? Any help would be greatly appreciated. I called Graphtec America in CA and even they don't...
  4.

    Grahtec FC7000 cutting abnormally

    I have a graphtec FC-7000MK2 with Illustrator. Off late it has started cutting straight lines with curves. Pls check the attached picture of a rounded rectangle cut on a oracal Vinyl where the upper line is straight one but the bottom one is a curved one..Both were supposed to be straight ones...
  5.

    Graphtec Help

    Hey guys. I'm having trouble with the Graphtec. whenever I try to cut an image everything seems to get out of line. For example if I'm trying to cut the letters A B C D. A will be in one place and B will be almost a quarter inch lower then C will over lap D. At first I was using FlexiEXPERT...
Top