• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

motor error

  1. Machine Reading "Y over current Ave" when in use.

    Hello all, I have a Mimaki CJV30-100 and im getting a message "y over current ave". It will do this in the initialising stage when the cutter carriage heads back to its position on the left. sometimes it will make it past this stage but when then when I test print or try to print the same...
  2.

    Roland CJ-500 Motor Error only when cutting

    Hi, I have a Roland CJ-500 that won't cut anything only prints. When I do a demo print it works fine but when I try a Demo Cut the cutting carriage starts and then immediately stops because of a motor error which doesn't throw any code or anything (just says motor error). I also reset the Motor...

  3. Motor is stuck and won't budge.

    Motor is stuck and won't budge. Message Says "motor error turn off power". In the past I was able to manually slide the motor casing back to position. Is ther a release button? It's a dinosaur, Roland fj-50

  4. Print Carriage Stops Moving Part Way Down The Track

    I have a Roland SC-500 that gives a motor error because the print carriage stops moving part way down the track when printing but when I use the SC-500 as a vinyl cutter it works fine. If I turn off the power and manually push the print carriage with the cutting carriage together down the track...
Top