I use a Roland Camm-1 Pro 1410 and output with Omega software.
The issue I'm having, is when it completes cutting a job, it always scrolls to the beginning of the job, even on sequence plot with specifically set start & end points, and then finally winds back up to the end of the job.
Is there anyway to override this function? I've looked through the manual and all the settings in Composer and I'm not seeing anything obvious
Any advise would be greatly appreciated.
Thanks in advance
The issue I'm having, is when it completes cutting a job, it always scrolls to the beginning of the job, even on sequence plot with specifically set start & end points, and then finally winds back up to the end of the job.
Is there anyway to override this function? I've looked through the manual and all the settings in Composer and I'm not seeing anything obvious
Any advise would be greatly appreciated.
Thanks in advance
