Bill Modzel
New Member
I'm running Illy CS3 on my Mac pro. Rightnow I have a rather large decal job that I'm printing in sets of 28 up per sheet using 4 corner registrations set with CM in Illy. I print them 5 sheets up on my HP9000 and than register and cut
them on my FC7000-100.
That all works fine but what's driving me nuts is when I set the 5 sheet multimple cut in CM it registers and cuts perfectly but no matter what box I check, after it cuts, it rewinds to the first sheet, searches for a registration mark and than errors out.
What am I missing? I just want it to stop after the 5th sheet and wait for me to send the next batch.
I've checked and unchecked "advance after plot" and it makes no difference.
Thanks
them on my FC7000-100.
That all works fine but what's driving me nuts is when I set the 5 sheet multimple cut in CM it registers and cuts perfectly but no matter what box I check, after it cuts, it rewinds to the first sheet, searches for a registration mark and than errors out.
What am I missing? I just want it to stop after the 5th sheet and wait for me to send the next batch.
I've checked and unchecked "advance after plot" and it makes no difference.
Thanks