Edges coming up

[borderswine]

Completed some wraps (not vehicle) with Instant One Media Cast Vinyl. Some of the edges were trimmed and tucked into creases, but the adhesive is not aggressive enough and they are coming up even after heated down w/ heatgun. I'm looking for a recommendation to get these edges to stay down long term. I was going to purchase 3M 8914 Edge Sealing Tape or 3M 3950 Edge Sealer.

The surface is slightly textured, but not much.

Thanks for any advice.

 

[BigfishDM]

3M Edge Seal should help you out with that.

 

[Niun]

We recently printed fifteen 6ft donor trees to be applied to clean flat walls, all using Instant One Media.... Every last one of them curled and/or bubbled and had to be replaced with IJ40. Most craptastic material I have used to date, so when you buy your Edge Sealer pens, be sure to get a few if your going to keep using that media.

 

[Split76]

We recently printed fifteen 6ft donor trees to be applied to clean flat walls, all using Instant One Media.... Every last one of them curled and/or bubbled and had to be replaced with IJ40. Most craptastic material I have used to date, so when you buy your Edge Sealer pens, be sure to get a few if your going to keep using that media.

That's just wrong vinyl for wall decals.. Even high tack vinyl can peel up from certain kind of paint.