• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

FC7000 origin start point

Kwiksigns

wookie
When the COMMAND setting is HP-GL, the origin point can be set to either the
lower left corner or center of the plotting area. When the COMMAND setting is GPGL,
this parameter is not available.
SETTING PROCEDURE
1 Press the MENU key.
2 Press the NEXT key until the following menu appears.
3 Press the F2 key (AREA PARAMETERS). The following menu appears.
Note: ORIGIN is only displayed when the COMMAND setting is HP-GL.
4 Press the F1 key (ORIGIN). The following menu appears.
5 The asterisk “*” indicates the currently selected setting. Press the F3 key to
select LOWER LEFT. Press the F4 key to select CENTER.
6 Press the ENTER key to register your settings.
7 Press the MENU key to return the plotter to Ready status.


Is that what you mean?
 
Top