Foli Stretching on Table Laminator

[VoytekD]

Hi,

I have a quite challenge with laminating glass panels on the table applicator (laminator). The foil is stretching under the roller pressure and on many occasions, it disciform the printed images on the foli.
I am trying to avoid printing any images that this kind of deformation could be noticeable but I would rather find a solution for that. I tried the application on the cold roller, warm roller, quick and slow application, I even reduced the pressure but still, the problem accrue. Do you have any ideas or solutions for this or a similar problem?

I would be grateful for any advice.

Thanks

 

[The Big Squeegee]

2
The Big Squeegee applies even pressure and applies the full width in one pass. Better than a roll laminator for this kind of job.