Gerber HS15 plus - stops cutting after 5 - 10 seconds

[Dennis Schaub]

I have two HS15 plus plotters that have served me very well over the years. Recently the one will start a job and promptly stop and start beeping after approx 10 seconds of cutting. I have switched power cords, data cords, computers, output job. It seems like something on the plotter side. Any ideas where I could start with a repair?

Thank You in advance!
-Dennis Schaub

 

[Cross Signs]

Something internal on the board is probably overheating. A resistor or capacitor. I have and old HS15 with the same problem. Never fixed it...put it in a closet.

 

[netsol]

not sure about beep codes
jimmy the plotter doctor?
562 706 9553

 

[netsol]

but, according to fred...

https://signs101.com/threads/plotter-stops-in-middle-of-cut-and-beeps.50183/