help for mimaki jv 33-260 Bs error 200

[sketch]

Hello everyone how are you
I suffer from error 200 in my printer problem is there who can solve the problem ..
I've tried everything Is there a managed solution ..thanks for every one can help.

help for mimaki jv 33-260 Bs error 200

 

[Commando]

Try turning off the main power. Leave it for a little while. Then start it back up. If it shows back up, good luck. Its most likely a problem with the computer.

 

[sketch]

thanks to replay
Commando
I try to do this but nothing change ..

 

[Commando]

thanks to replay
Commando
I try to do this but nothing change ..

That sucks. I would call tech support. Could be the computer. Good luck!

 

[SightLine]

Its an electrical issue. 200 is the head memory board BUT it could be the head itself, the slider board, damaged or no properly connected head cables or cables between the slider board and main board. My guess is the head cable is not fully seated, has damage, or had ink run down it and into the head connectors. Have you replaced the print head in the printer?

 

[rodrigo_toledo]

I was with this problem recently, I JV33-160. second technical manual:


1. Check the head memory cable
2. replace the headmemory
3. replace the ink slider pcb assy
4. replace the ma pcb ssy


1 to 3 tests, not changed the mother board, so managed to solve the replacement of the flat cable of ink slider pcb assy.