Ink splatter drops on SP300v

[dsstrainer]

Hi all, I've been seeing some ink splatter drops on my prints.... I'd see them time to time but they seem to be getting worse now and I'm not sure what the cause it. I thought it was the wipers so I cleaned them fully but that didn't really help. I just did a full maintenance mode cleaning a week ago and it seemed like it didn't help much. Any ideas where the culprit is? See attached image for what I'm talking about.

 

[Terry01]

A test print would be helpful

 

[ChicagoGraphics]

Check around your print head, you might have some fuzzy strains from banner material that causes it a lot of times

 

[jharler]

I notice I get these after not cleaning the print heads for a while. A manual cleaning tends to clear them up.

 

[Mike Paul]

Manual Cleaning yes

 

[dsstrainer]

Yep.. that was definitely it.. I did another manual cleaning around the heads and made sure there were no stray fibers from the swabs or anything else and sure enough all good now. Thx!