-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
Ionizer bars, guns.
- Thread starter chafro
- Start date
DieselPoweredNun
New Member
I know this post is old, but...
Any other favorites on ionizers?
We are looking into a gun/blower for difficult materials and I see talk of them on past posts, but not a brand or model discussion with pros/cons.
Right now I'm only in the research phase so I have tons of models/styles to look at, but reviews are not always easy to come by so seeing what people use and like would be super helpful.
Any other favorites on ionizers?
We are looking into a gun/blower for difficult materials and I see talk of them on past posts, but not a brand or model discussion with pros/cons.
Right now I'm only in the research phase so I have tons of models/styles to look at, but reviews are not always easy to come by so seeing what people use and like would be super helpful.
DieselPoweredNun
New Member
I have the 4125 from those guys is on the "evaluate further" list!
johnnysigns
New Member
We bought a chinese copy off amazon similar to this: https://www.amazon.com/Antistatic-G...sprefix=ionizing+air+gun,tools,48&sr=1-4&th=1
DieselPoweredNun
New Member
How do you like it and does it do the job?
I have looked at ones like that on Amazon too, but with so few reviews it's hard to pull an average sentiment.
I do LOVE the idea of saving $ if I can and the non-amazon ones are pricey to say the least, so your thoughts would be greatly appreciated!
johnnysigns
New Member
It works awesome honestly. We do a lot of acrylic fabrication and it's indispensable to dust component parts or finished parts during assembly.
FireSprint.com
Trade Only Screen & Digital Sign Printing
We have mounted a couple of keyence bars to the infeeds of our printers with good results.
Troy Lesher
New Member
Kenyence makes very good static neutralizers,, we build our printers with them. We tried so many "static bars" during out R&D phase and most don't do squat regardless of how much they cost. .. IN addition the HUmidity should be above 45% and that will eliminate quite a bit of your static issue as well.
DieselPoweredNun
New Member
We have been working on the humidity levels, and now that it's spring again we are back up in the 50's on average.
During the winter it was worse when we were lucky to get to 20%. Far more problems then.
White acrylic and certain types of non-glare lens material seem to be the worst offenders. Well that and clear vinyl. Even with the RH up these few materials are just bad with the static here.
During the winter it was worse when we were lucky to get to 20%. Far more problems then.
White acrylic and certain types of non-glare lens material seem to be the worst offenders. Well that and clear vinyl. Even with the RH up these few materials are just bad with the static here.
Adam Vreeke
Knows just enough to get in a lot of trouble..
How did this run for you? We are looking for one here, and thinking about getting this one, but still only 14 reviews on Amazon.
johnnysigns
New Member
It works fine. We bought one that had two spray guns so as one aged or got dropped too many times we just popped in the second sprayer as a refresh. The only gripe is the electrical wiring to the spray gun is only 6ft or so which is a pain in the neck sometimes. We keep ours on a cart that we have to keep close to where we're using it.