Stick It On
New Member
Hi
I attempted to run a discharge and wash on my JV33 as I have been having trouble with ink not passing through to the heads. Ended up wasting the ink in the lines that were making it through the heads, while the ones with blockages did not drain at all. To top this off I did not realise I needed 8 cleaning cartridges to perform the discharge and wash, so had to abandon the process.
My problem now is that when I try to perform the initial ink fill up, I insert the ink cartridges but nothing happens (instructions say fill should start automatically). Some of the cartridges are empty but at least one of every colour (4 colour setup) contains ink. The Yellow cartridge is at about 10% but I am not getting an INK NEAR END error message so I assume this is not a problem.
Has anyone encountered an ink fill problem like this?
Thanks
I attempted to run a discharge and wash on my JV33 as I have been having trouble with ink not passing through to the heads. Ended up wasting the ink in the lines that were making it through the heads, while the ones with blockages did not drain at all. To top this off I did not realise I needed 8 cleaning cartridges to perform the discharge and wash, so had to abandon the process.
My problem now is that when I try to perform the initial ink fill up, I insert the ink cartridges but nothing happens (instructions say fill should start automatically). Some of the cartridges are empty but at least one of every colour (4 colour setup) contains ink. The Yellow cartridge is at about 10% but I am not getting an INK NEAR END error message so I assume this is not a problem.
Has anyone encountered an ink fill problem like this?
Thanks