• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Need Help Mutoh VJ1204 Print problem missing half black HELP

scott dunacn

adgrafix
Mutoh VJ1204 Everything is perfect except the one section. Done everything except new print head.
the first test print only half black is working so i saw this post. A good way to troubleshoot is to simply swap the black damper's positions, run a cleaning cycle and then another test print. If the channel that wasn't printing before still isn't printing, most likely your head is fried. If the problem moves however, it could be an air leak or plumbing issue above the head that is causing the issue. It could also just be clogged in which case a good head soak and strong cleaning should help if not a full on manual flush with a syringe. so i put new dampers on black new 0 ring 20200512_182624.jpg this is before the test print 20200512_182633.jpg this is after cleaning and this a print 20200512_182517.jpg please help
 

Attachments

  • 20200512_182633.jpg
    20200512_182633.jpg
    1 MB · Views: 386

Modman

New Member
Keep running the clean cycles and see if it gradually improves also check your drain tubes leading down into waste bottle to make sure your not partially plugged off
 

scott dunacn

adgrafix
cleaned the manifold, 5 cleanings, new dumpers, 0 ring, brass nuts works like a new one
 

Attachments

  • 20200513_173951.jpg
    20200513_173951.jpg
    956.3 KB · Views: 341
  • 20200513_174012.jpg
    20200513_174012.jpg
    2.1 MB · Views: 325
Top