I want a machine that can rip 8ft sheets of ACM, polymetal or diebond, etc. other than the venerable table saw. Rarely use anything thicker than the 3mm. Along with coro, foamboad, sintra.
I have been considering the 98" Keencut steeltrak. In looking at some earlier posts there was a note about someone using an Evolution table cutter, scoring and then snapping the acm apart. This gives me pause because there is quite a difference in the price of the 98" steeltrak vs the 104" evolution.
Can anyone give some practical user advice as to which would be better solution from an operation standpoint?
I have been considering the 98" Keencut steeltrak. In looking at some earlier posts there was a note about someone using an Evolution table cutter, scoring and then snapping the acm apart. This gives me pause because there is quite a difference in the price of the 98" steeltrak vs the 104" evolution.
Can anyone give some practical user advice as to which would be better solution from an operation standpoint?