Orajet 3651Intermediate Calendared - Ok W/Rapid Tac

[gemhdsigns]

Hi!
Question: Have a large 60” Diameter backlit install which we’re using Orajet 3651 (not 3651RA). It’s been a challenge eliminating bubbles on this large install - having to reprint.

Any issues / concerns with using Rapid Tac with this media?

I typically stick with dry installs but I feel like with this material, and this size print, it might be best to install wet.

Would welcome thoughts

Thank you!!

 

[jcskikus]

Use RapidTac lightly. Test it with a smaller piece on the surface you'll be applying to. If it gets too wet, it's best to make sure all bubbles are out and either let dry time or use a heat gun to speed the adhesion process. You using 210 or 290 as overlaminate?

 

[unmateria]

Hi 3651 is not for backlights. But anyway, use wet method always u use acrylics

 

[CanuckSigns]

3651 has a tinted adhesive, so it is not the correct product for a backlit sign, but yes you can use rapid tac on it no issues.

 

[gemhdsigns]

Use RapidTac lightly. Test it with a smaller piece on the surface you'll be applying to. If it gets too wet, it's best to make sure all bubbles are out and either let dry time or use a heat gun to speed the adhesion process. You using 210 or 290 as overlaminate?

Thank you.. Using 210 for laminate.

 

[gemhdsigns]

Hi 3651 is not for backlights. But anyway, use wet method always u use acrylics

We’re using 3651 transparent gloss over white 7328 cast acrylic. Used this for smaller contour cut applications without issue. This project is a large sheet 60” diameter.