Ian Stewart-Koster
Older Greyer Brushie
HI all, our router used to have a knife & pen holder. That's long since been lost by a former owner.
I'm keen to get a plotter blade holder going again for it, for plotting big signs through the coversheet of dibond etc. (the router has a 2.0 x 3.6 metre bed)
The old one used to have some kind of weights system for altering the blade pressure. The holder attached beside the actual router- with a 3" x axis offset.
It was an Esab signmate 1000, later rebuilt with Tekcel drives & controllers on all three axes.
Does anyone have a plotterblade holder they could post pictures of (&/or measurements of) so I can see what it was like?
I have a spare Roland Camm1 blade holder I was planning to adapt.It's the pressure adjustment I'm unsure about.
Thanks!
I'm keen to get a plotter blade holder going again for it, for plotting big signs through the coversheet of dibond etc. (the router has a 2.0 x 3.6 metre bed)
The old one used to have some kind of weights system for altering the blade pressure. The holder attached beside the actual router- with a 3" x axis offset.
It was an Esab signmate 1000, later rebuilt with Tekcel drives & controllers on all three axes.
Does anyone have a plotterblade holder they could post pictures of (&/or measurements of) so I can see what it was like?
I have a spare Roland Camm1 blade holder I was planning to adapt.It's the pressure adjustment I'm unsure about.
Thanks!